Accton Technology ES4626 - Manual (Page 64)

64
informational 6
Informational messages
debugging 7
Debug-level messages
Right now the switch can generate information of following four levels
z Restart the switch, mission abnormal, hot plug on the CHASSIS switch chips are
classified critical
z Up/down switch, topology change, aggregate port state change of the interface
are classified warnings
z Outputted information from the CLI command is classified informational
z Information from the debugging of CLI command is classified debugging
Log information can be automatically sent to corresponding channels with regard to
respective severity levels. Amongst the debugging information can only be sent to the
monitor. Those with the Informational level can only be sent to current monitor terminal,
such as the information from the Telnet terminal configuration command can only be
transmitted to the Telnet terminal. Warnings information can be sent to all terminal with
also saved in the SDRAM log buffer zone. And the critical information can be save both in
SDRAM and the NVRAM (if exists) besides sent to all terminals. To check the log save in
SDRAM and the NVRAM, we can use the show logging buffered command. To clear the
log save in NVRAM and SDRAM log buffer zone, we can use the clear logging command
2.2.9.2 System Log Configuration
2.2.9.2.1 System Log Configuration Task Sequence
1. Display and clear log buffer zone
2. Configure the log host output channel
1. Display and clear log buffer zone
Command Description
Admin Mode
show logging buffered [level { critical |
warnings} | range <begin-index>
<end-index>]
Show detailed log information in
the log buffer channel
clear logging { sdram | nvram } Clear log buffer zone information
2. Configure the log host output channel
Command Description
Global Mode