12 shutdown, 13 speed-duplex – Accton Technology ES4626 User Manual
Page 139
139
of the data packets; while for vlan interfaces, the port MAC address, IP address and the
statistic state of the data packet will be shown; for aggregated port, port speed rate,
duplex mode, flow control switch state, broadcast storm restrain of the port and the
statistic state of the data packets will be displayed. All information of all ports on the
switch will be shown if no port is specified.
Example：
Show the information of Port 1/1
Switch#show interface status ethernet 1/1
Hardware is Gigabit-TX,address is 00-00-00-00-00-02
PVID is 1
MTU 1500 bytes,BW 10000 Kbit
Encapsulation ARPA,Loopback not set
Auto-duplex:Negotiation half-duplex, Auto-speed: Negotiation 10M bits
FlowControl is off, MDI type is auto
3.2.1.2.12 shutdown
Command: shutdown
no shutdown
Function:
Shuts down the specified Ethernet port; the “no shutdown” command opens
the port.
Command mode:
Interface Mode
Default:
Ethernet port is open by default.
Usage Guide:
When Ethernet port is shut down, no data frames are sent in the port, and
the port status displayed when the user types the “show interface” command is “down”.
Example:
Opening ports 1/1-8.
Switch(Config)#interface ethernet1/1-8
Switch(Config-Port-Range)#no shutdown
3.2.1.2.13 speed-duplex
Command:speed-duplex {auto | force10-half | force10-full | force100-half |
force100-full | { {force1g-half | force1g-full} [nonegotiate [master | slave]] } }
no speed-duplex
Function:
Sets the speed and duplex mode for 1000Base-TX or 100Base-TX ports; the
“no speed-duplex” command restores the default speed and duplex mode setting, i.e.,
auto speed negotiation and duplex.
Parameters:
auto for auto speed negotiation; force10-half for forced 10Mbps at
half-duplex; force10-full for forced 10Mbps at full-duplex mode; force100-half for forced
100Mbps at half-duplex mode; force100-full for forced 100Mbps at full-duplex mode;
force1g-half
for forced 1000Mbps at half-duplex mode; force1g-full for forced
1000Mbps at full-duplex mode; nonegotiate for disable auto-negotiation for 1000 Mb