Accton Technology ES4626 - Manual (Page 686)

686
17.1.3.1 ipv6 pim dense-mode
Command: ipv6 pim dense-mode
no ipv6 pim dense-mode
Function: Enable PIM-DM protocol on interface; the “no ipv6 pim dense-mode”
command disenables PIM-DM protocol on interface.
Parameter:
None
Default: Disable PIM-DM protocol
Command Mode: Interface Configure Mode
Usage Guide: The command will be taken effect, executing ipv6 multicast-routing in
Global Mode.Don’t support multicast protocol mutual operation, namely can’t
synchronously enable dense mode and sparse mode in one swtich. The command can
configure on IPv6 tunnel interface, but it is successful configuration to only configure
tunnel carefully.
Example: Enable PIM-DM protocol on interface vlan1.
Switch (Config)#ipv6 pim multicast-routing
Switch (Config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 pim dense-mode
17.1.3.2 ipv6 pim dr-priority
Command: ipv6 pim dr-priority
no ipv6 pim dr-priority
Function: Configure, cancel and change priority value of interface DR. The same net
segment border nodes vote specified router DR in this net segment through hello
messages, the “no ipv6 pim dr-priority” restores default value.
Parameter: < priority> priority, value range from 0 to 4294967294
Default: 1
Command Mode:
Interface Configuration Mode
Usage Guide: Value range is from 0 to 4294967294, the bigger value, the more priority.
The command can configure on IPv6 tunnel interface, but it is successful configuration to
only configure tunnel carefully.
Example: Switch (Config)# interface vlan 1
Switch(Config-if-Vlan1)ipv6 pim dr-priority 100
17.1.3.3 ipv6 pim exclude-genid
Command
: ipv6 pim exclude-genid
no ipv6 pim exclude-genid
Function: The command make Hello message transmitted by PIM-SM exclude Genid
option, the “no ipv6 pim exclude-genid” restores default value.