Accton Technology ES4626 - Manual (Page 487)

487
1. Enable OSPFv3 (required)
（ 1） Enable/disable OSPFv3(required)
（ 2） Configure the router-id number of the layer3 switch running OSPFv3
(optional)
（ 3） Configure the network scope for running OSPFv3 (optional)
（ 4） enable OSPFv3 on the interface (required)
2. Configure OSPFv3 auxiliary parameters (optional)
（ 1） Configure OSPFv3 package sending mechanism parameters
1) Set the OSPFv3 interface to receive only
2) Configure the cost for sending packages from the interface
3) Configure OSPF package sending timer parameter (timer of broadcast
interface sending HELLO package to poll, timer of neighboring layer3 switch
invalid timeout, timer of LSA transmission delay and timer of LSA
retransmission.
（ 2） Configure OSPFv3 route introduction parameters
1) Configure default parameters (default type, default tag value, default cost)
2) Configure the routes of the other protocols to introduce to OSPFv3
（ 3） Configure other OSPF protocol parameters
1) Configure OSPF routing protocol priority
2) Configure cost for OSPF STUB area and default route
3) Configure OSPF virtual link
4) Configure the priority of the interface when electing designated layer3 switch
3. Close OSPFv3 Protocol
1. Enable OSPFv3 Protocol
It is very simple to run the basic configurations of OSPFv3 routing protocol on the
Layer 3 switch of ES4624-SFP/ES4626-SFP switch, normally only enabling OSPFv3,
implement OSPFv3 interface, the default value is defined to OSPFv3 protocol
parameters. Refer to 2. Configure OSPF auxiliary parameters, if the OSPFv3 protocol
parameters need to be modified.
Commands Explanation
Global mode
[no] router IPv6 ospf
The command initializes ospfv3 routing
process and enter ospfv3 mode to
configure ospfv3 routing process. The
[no] router IPv6 ospf command
stops relative process. (required)
OSPFv3 Protocol Configure Mode