Accton Technology ES4626 - Manual (Page 27)

27
1.2.2.2 Admin Mode
To Admin Mode sees the following: In user entry system, if as Admin user, it is
defaulted to Admin Mode. Admin Mode prompt “Switch#” can be entered under the User
Mode by running the enable command and entering corresponding access levels admin
user password, if a password has been set. Or, when exit command is run under Global
Mode, it will also return to the Admin Mode. ES4624-SFP/ES4626-SFP Switch also
provides a shortcut key sequence "Ctrl+z”, this allows an easy way to exit to Admin Mode
from any configuration mode (except User Mode).
Under Admin Mode, when disable command is run, it will return to User Mode. When
exit command is run, it will exit the entry and enter user entry system direct. Next users
can reenter the system on entering corresponding user name and password.
Under Admin Mode, the user can query the switch configuration information,
connection status and traffic statistics of all ports; and the user can further enter the
Global Mode from Admin Mode to modify all configurations of the switch. For this reason,
a password must be set for entering Admin mode to prevent unauthorized access and
malicious modification to the switch.
1.2.2.3 Global Mode
Type the config command under Admin Mode will enter the Global Mode prompt
“Switch(Config)#”. Use the exit command under other configuration modes such as
Interface Mode, VLAN mode will return to Global Mode.
The user can perform global configuration settings under Global Mode, such as MAC
Table, Port Mirroring, VLAN creation, IGMP Snooping start, GVRP and STP, etc. And the
user can go further to Interface Mode for configuration of all the interfaces.
1.2.2.4 Interface Mode
Use the interface command under Global Mode can enter the interface mode
specified. ES4624-SFP/ES4626-SFP Switch provides three interface type: VLAN
interface, Ethernet port and port-channel, and accordingly the three interface
configuration modes.
Interface
Type
Entry Prompt Operates Exit
VLAN
Interface
Type interface
vlan
command under
Global Mode.
Switch(Config-If-
Vlanx)#
Configure
switch IPs, etc
Use the exit
command to
return to
Global Mode.
Ethernet Port Type interface
ethernet
Switch(Config-
ethernetxx)#
Configure
supported
Use the exit
command to