Accton Technology ES4626 - Manual (Page 717)

717
messages include General Query and Specific Group Query. General Query uses the
multicast address FF02::1 of hosts as destination address, the group address is 0; and
Specific Group Query use its group address as destination address. The multicast
addresses of MLD use 130, 131 and 132 as data types denoting the three kinds of
messages mentioned above. Other logic is basically same as IGMPv2.
17.3.2 MLD Configuration Task List
1、 Start MLD (Required)
2、 Configure MLD auxiliary parameters (Required)
（ 1）Configure MLD group parameters
1）Configure MLD group filter conditions
（ 2）Configure MLD query parameters
1）Configure the interval of MLD sending query message
2）Configure the maximum response time of MLD query
3）Configure overtime of MLD query
3、 Shut down MLD Protocol
1. Start MLD Protocol
There is no special commands for starting MLD Protocol on EDGECORE series
layer 3 switches. MLD Protocol will automatically start up as long as any IPv6 multicast
protocol is started on corresponding interface.
Command Explanation
Global Mode
Ipv6 pim multicast-routing
To start Global IPv6 Multicast Protocol, the
precondition of starting MLD Protocol. The
NO operation of corresponding command
shuts ipv6 multicast protocol and MLD
Protocol. (Required)
Command Explanation
Port Configuration Mode
ipv6 pim dense-mode | ipv6 pim
sparse-mode
Start MLD Protocol. The NO operation of
corresponding command shuts MLD Protocol.
(Required)
2. Configure MLD auxiliary parameters
（1）Configure MLD group parameters
1） Configure MLD group filter conditions
Command Explanation