Accton Technology ES4626 - Manual (Page 131)

131
Chapter 3 Port Configuration
3.1 Introduction to Port
ES4624-SFP/ES4626-SFP Switch comes with 8 Gigabit Combo ports , 16 SFP
Gigabit fiber ports and （for ES4626-SFP） 2 SFP 10G fiber ports. The Combo ports can
be configured to as either 1000GX-TX ports or Gigabit fiber ports.
If the user needs to configure some network ports, he/she can use the “interface
ethernet ” command to enter the appropriate Ethernet port configuration
mode, where stands for one or more ports. If contains
multiple ports, special characters such as “;” or “-” can be used to separate ports, “;” is
used for discrete port numbers and “-” is used for consecutive port numbers. Suppose an
operation should be performed on ports 2, 3, 4, 5, 8, 9, 10, the command would look like:
interface ethernet 1/2-5;1/8-10. Port speed, duplex mode and traffic control can be
configured under Ethernet Port Mode causing the performance of the corresponding
network ports to change accordingly.
3.2 Port Configuration
3.2.1 Network Port Configuration
3.2.1.1 Network Port Configuration Task List
1. Enter the network port configuration mode
2. Configure the properties for the network ports
（ 1） Configure combo mode for combo ports
（ 2） Enable/Disable ports
（ 3） Configure port names
（ 4） Configure port cable types
（ 5） Configure port speed and duplex mode
（ 6） Configure bandwidth control
（ 7） Configure traffic control
（ 8） Enable/Disable port loopback function
（ 9） Configure broadcast storm control function for the switch
1. Enter the Ethernet port configuration mode