13 clear cluster candidate-table, 4 examples of cluster administration – Accton Technology ES4626 User Manual
Page 850
850
65535.
Command mode:
The interval of heartbeat is 8 seconds by default.
Default:
Global Mode
Instructions:
In the commander switch, this command is used to set the interval of
heartbeat. And this information is distributed to all the member switches. If this command
is executed in a non-commander switch and the value is more than the current holdtime,
the setting is invalid and an error is displayed.
Example:
Set the interval of sending heartbeat packets of the cluster to 10 seconds.
Switch(config)#cluster heartbeat 10
22.1.3.13 clear cluster candidate-table
Command: clear cluster candidate-table
Function:
Clear the list of candidate switches discovered by the commander switch.
Command mode:
Admin Mode
Instructions:
In the commander switch, this command is used to clear the list of
candidate switches discovered by the commander switch. If this command is executed in
a non-commander switch, an error will be displayed.
Example:
Clear the list of candidate switches discovered by the commander switch
Switch#clear cluster candidate-table
22.1.4 Examples of Cluster Administration
Scenario
The four switches SwitchA-SwitchD, amongst the SwitchA is the command switch and
other switches are member switch. The SwitchB and SwitchD is directly connected with
the command switch, SwitchC connects to the command switch through SwitchB
Fig 22-1 Examples of Cluster
Configuration Procedure
1. Configure the command switch
Configuration of SwitchA
Switch(Config)#cluster run
Switch(Config)#cluster ip-pool 1.2.3.4