Accton Technology ES4626 - Manual (Page 405)

405
Default: Version 2
Command Mode:
Interface Mode
Example: Switch# config terminal
Switch(config)# interface vlan 1
Switch(Config-if-Vlan1)# ip rip send version 1
13.4.3.18 ip rip split-horizon
Command: ip rip split-horizon [poisoned]
no ip rip split-horizon
Function: Enable split horizon. The “no ip rip split-horizon” disables the split horizon.
Parameter: [poisoned] means configure the split horizon with poison reverse.
Default: Split Horizon with poison reverse by default
Command Mode: Interface Mode
Usage Guide: The split horizon is for preventing the Routing Loops, namely preventing
the layer 3 switches from broadcasting the routes which is learnt from the same interface
on which the route to be broadcasted.
Example: Switch# config terminal
Switch(config)# interface vlan 1
Switch(Config-if-Vlan1)# ip rip split-horizon poisoned
13.4.3.19 key
Command: key <keyid>
no key
Function: This command is for managing and adding keys in the key chain. The “no key
“ command deletes one key.
Parameter: <keyid> is key ID, ranging between 0-2147483647.
Command Mode: Keychain mode
Usage Guide: The command permits entering the keychain-key mode and set the
passwords corresponding to the keys.
Example:
Switch# config terminal
Switch(config)# key chain mychain
Switch(config-keychain)# key 1
Switch(config-keychain-key)#
Relevant Commands: key chain, key-string, accept-lifetime, send-lifetime
13.4.3.20 key chain
Command: key chain
no key chain < name-of-chain >