Accton Technology ES4626 - Manual (Page 656)

656
16.4.5.1.5 show ip dvmrp pr
Command: show ip dvmrp pr [{group [detail]}|{source
group [detail]}|{source [detail] }|detail]
Function: Display DVMRP message forwarding item.
Parameter: None
Default:
Do not display
Command Mode: Any Configuration Mode
Usage Guide: This command applies to display DVMRP multicast forwarding item,
namely multicast forwarding table calculated by dvmrp protocol.
Example:
Switch#show ip dv prune
Flags: P=Pruned,H=Host,D=Holddown,N=NegMFC,I=Init
Source Mask Group State FCR Exptime Prune/Graft
Address Len Address Cnt ReXmit-Time
13.1.1.0 24 239.0.0.1 ..... 1 01:59:56 Off
Displayed Information Explanations
Source Address Source address
Mask Len Mask length
Group Address Group address
State Table item state
FCR Exptime FCR expire time
Prune/Graft ReXmit-Time Prune expire time/ Graft retransmit time
16.4.5.1.6 show ip dvmrp route
Command: show ip dvmrp route [{[detail]}|{nexthop
[detail]}|{best-match [detail]}|detail]
Function: Prune expire time/ Graft retransmit time
Parameter: None
Default: Do not display
Command Mode: Any Configuration Mode
Usage Guide: The command applies to display DVMRP routing table item; DVMRP
maintains individual unicast routing table to check RPF.
Example:
Display DVMRP routiing.
Switch #show ip dv route
Flags: N = New, D = DirectlyConnected, H = Holddown
Network Flags Nexthop Nexthop Metric Uptime Exptime
Xface Neighbor
10.1.35.0/24 .D. Vlan2 Directly Connected 1 00:11:16