Accton Technology ES4626 - Manual (Page 42)

42
Extended commands [n]: Whether to change the other options or not
2.1.1.20 ping6
Command: ping6 [<dst-ipv6-address> | host | src < src-ipv6-address >
{- ipv6-address > | host } ]
Function:
Verify the accessibility of the network
Parameter： - ipv6-address > is the destination IPv6 address,< src-ipv6-address >
is the source IPv6 address, is the host name of the remote host,containing
no more than 30 characters.
Default: None
Command Mode: User Mode
Usage Guide: Ping6 followed by IPv6 address is the default configuration. Ping6 function
can configure the parameters of the ping packets on users’ demands. When the
ipv6-address is the local link address, a vlan interface name is needed to be specified.
When specifying source IPv6 address, the sent icmp query packets will use specified
source IPv6 address as the source address of the ping packets.
Example:
(1) Default parameters of the ping6 program
Switch>ping6 2001:1:2::4
Type ^c to abort.
Sending 5 56-byte ICMP Echos to 2001:1:2::4, timeout is 2 seconds.
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/320/1600 ms
(2) Specify source IPv6 address when using ping6
switch>ping6 src 2001:1:2::3 2001:1:2::4
Type ^c to abort.
Sending 5 56-byte ICMP Echos to 2001:1:2::4, using src address 2001:1:2::3, timeout is
2 seconds.
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
(3) Modify ping6 parameter with the help of the ping6 program
switch>ping6
Target IPv6 address:fe80::2d0:59ff:feb8:3b27
Output Interface: vlan1
Use source address option[n]:y
Source IPv6 address: fe80::203:fff:fe0b:16e3
Repeat count [5]:
Datagram size in byte [56]: