Accton Technology ES4626 - Manual (Page 146)

146
another port. The duplicated port is referred to as mirror source port and the duplicating
port is referred to as mirror destination port. A protocol analyzer (such as Sniffer) or
RMON monitoring instrument is often attached to the mirror destination port to monitor
and manage the network and diagnostic.
ES4624-SFP/ES4626-SFP switch support one mirror destination port only. The
number of mirror source ports are not limited, one or more may be used. Multiple source
ports can be within the same VLAN or across several VLANs. The destination port and
source port(s) can be located in different VLANs.
3.3.2 Port Mirroring Configuration Task List
Specify mirror source port and dentistination port
3.3.3 Commands for Mirroring Configuration
3.3.3.1 port monitor
Command：port monitor interface {rx| tx| both}
no port monitor interface
Function ： Specifies port of mirror source; the “no port monitor interface
” command deletes the mirror source port.
Parameter： is the mirror source port list, in which special characters
such as “-”、“;” are available; rx is the flow received from the source port;tx is the flow
sent from the source port ;both refers to the flow both into and out from the mirror source
Command Mode： Interface mode
Usage Guide：
This command is for configuring the source port of the mirror. There is not
Command Explanation
Port mode
port monitor interface {rx| tx|
both}
no port monitor interface
Specifies mirror dentist port
port monitor interface
{rx| tx|
both}, the
refer to the source ports
; the “no port monitor
interface } ”
command deletes mirror
port.