Accton Technology ES4626 - Manual (Page 269)

269
Switch(Config-Ethernet1/1)#mls qos trust cos pass-through dscp
Switch(Config-Ethernet1/1)#mls qos cos 5
Configuration result:
When QoS enabled in Global Mode, the egress queue bandwidth proportion of port
ethernet 1/1 is 1:1:2:2:4:4:8:8. When packets have CoS value coming in through port
ethernet 1/1, it will be map to the queue out according to the CoS value, CoS value 0 to 7
correspond to queue out 1, 2, 3, 4, 5, 6, 7, 8, respectively. If the incoming packet has no
CoS value, it is default to 5 and will be put in queue 6. All passing packets would not have
their DSCP values changed.
Scenario 2:
In port ethernet 1/2, set the bandwidth for packets from segment 192.168.1.0 to 10
Mb/s, with a burst value of 4 MB, all packets exceed this bandwidth setting will be
dropped.
The configuration steps are listed below:
SWITCH#CONFIG
Switch(Config)#access-list 1 permit 192.168.1.0 0.0.0.255
Switch(Config)#mls qos
Switch(Config)#class-map c1
Switch(Config-ClassMap)#match access-group 1
Switch(Config-ClassMap)# exit
Switch(Config)#policy-map p1
Switch(Config-PolicyMap)#class c1
Switch(Config--Policy-Class)#police 10000 4000 exceed-action drop
Switch(Config--Policy-Class)#exit
Switch(Config-PolicyMap)#exit
Switch(Config)#interface ethernet 1/2
Switch(Config-Ethernet1/2)#service-policy input p1
Configuration result:
An ACL name 1 is set to matching segment 192.168.1.0. Enable QoS globally,
create a class map named c1, matching ACL1 in class map; create another policy map
named p1 and refer to c1 in p1, set appropriate policies to limit bandwidth and burst
value. Apply this policy map on port ethernet 1/2. After the above settings done,