Accton Technology ES4626 - Manual (Page 517)

517
（ 6）Configure Next-Hop
1） Set Next-Hop as the switch’s address
Command Explanation
BGP configuration mode
neighbor { | }
next-hop-self
no neighbor { | }
next-hop-self
While sending route Next-Hop set
Next-Hop as the switch’s address; the no
neighbor { | }
next-hop-self command cancels the
setting.
2）Cancel default Next-Hop through route map
Command Explanation
Route mapped configuration command
set ip next-hop
no set ip next-hop
Set the Next-Hop attribute of outbound
route. The no set ip next-hop command
cancels this setting.
（ 7）Configure EGBP Multi-Hop
If the connections with outer neighbors are not direct, the following command can
configure neighbor Multi-Hop.
Command Explanation
BGP configuration mode
neighbor {|}
ebgp-multihop [<1-255>]
no neighbor {|}
ebgp-multihop [<1-255>]
Configure the allowance of
EBGP connection with other
networks that are not connected
directly; the no neighbor
{|}
ebgp-multihop [<1-255>]
command cancels the setting.
（ 8）Configure BGP session identifier
Command Explanation
BGP configuration mode
bgp router-id
no bgp router-id
Configure the router-id value; the no bgp
router-id command recovers the default
value.