Accton Technology ES4626 - Manual (Page 21)

21
2) The host IP address (Telnet client) and the switch’s VLAN interface IP address is
in the same network segment.
3) If not 2), Telnet client can connect to an IP address of the switch via other
devices, such as a router.
ES4624-SFP/ES4626-SFP Switch is a Layer 3 switch that can be configured with
several IP addresses. The following example assumes the shipment status of the switch
where only VLAN1 exists in the system.
The following describes the steps for a Telnet client to connect to the switch’s VLAN1
interface by Telnet.
Fig 1-6 Manage the switch by Telnet
Step 1: Configure the IP addresses for the switch
First is the configuration of host IP address. This should be within the same network
segment as the switch VLAN1 interface IP address. Suppose the switch VLAN interface
IP address 10.1.128.251/24. Then, a possible host IP address is 10.1.128.252/24. Run
“ping 10.1.128.251” from the host and verify the result, check for reasons if ping failed.
The IP address configuration commands for VLAN1 interface are listed below.
Before in-band management, the switch must be configured with an IP address by
out-of-band management (i.e. Console mode), The configuration commands are as
follows (All switch configuration prompts are assumed to be “switch” hereafter if not
otherwise specified):
Switch>
Switch>en
Switch#config
Switch(Config)#interface vlan 1
Switch(Config-If-Vlan1)#ip address 10.1.128.251 255.255.255.0
Switch(Config-If-Vlan1)#no shutdown