Accton Technology ES4626 - Manual (Page 482)

482
Command Mode: All modes
Example:
Switch#show ip ospf virtual-links
Virtual Link VLINK0 to router 10.10.0.9 is up
Transit area 0.0.0.1 via interface Vlan1
Transmit Delay is 1 sec, State Point-To-Point,
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:02
Adjacency state Full
Virtual Link VLINK1 to router 10.10.0.123 is down
Transit area 0.0.0.1 via interface Vlan1
Transmit Delay is 1 sec, State Down,
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in inactive
Adjacency state Down
13.6.5.1.15 show ip protocols
Command: show ip protocols
Function:
Display the running routing protocol messages
Default: None
Command Mode: All modes
Example:
show ip protocols
Use show ip protocol command will show the messages of the routing protocol running
on current layer 3 switch
For example, the displayed messages are:
Routing Protocol is "ospf 0"
Invalid after 0 seconds, hold down 0, flushed after 0
Outgoing update filter list for all interfaces is
Incoming update filter list for all interfaces is
Redistributing:
Routing for Networks:
10.1.1.0/24
12.1.1.0/24
Routing Information Sources:
Gateway Distance Last Update
Distance: (default is 110)
Address Mask Distance List