Accton Technology ES4626 - Manual (Page 460)

460
poll-interval should be much larger than the hello-interval
Example:
Switch#config terminal
Switch(config)#router ospf 100
Switch(config-router)#neighbor 1.2.3.4 priority 1 poll-interval 90
Switch(config-router)#neighbor 1.2.3.4 cost 15
13.6.3.32 network area
Command: network NETWORKADDRESS area <area-id>
no network NETWORKADDRESS area <area-id>
Function: This command enables OSPF routing function one the interface with IP
address matched with the network address. The “no network NETWORKADDRESS
area <area-id> “ command removes the configuration and stop OSPF on corresponding
interface.
Parameter: NETWORKADDRESS = A.B.C.D/M | A.B.C.D X.Y.Z.W, Shown with the
network address prefix or the mask. Wildcast mask if shown in mask; <area-id> is the ip
address or area number shown in point divided demical system, if shown in demcial
integer, it ranges between 0~4294967295
Default: No default
Command Mode: OSPF protocol mode
Usage Guide: When certain segment belongs to certain area, interface the segment
belongs will be in this area, starting hello and database interaction with the connected
neighbor.
Example:
Switch#config terminal
Switch(config)#router ospf 100
Switch(config-router)#network 10.1.1.0/24 area 1
13.6.3.33 ospf abr-type
Command: ospf abr-type {cisco|ibm|shortcut|standard}
no ospf abr-type
Function: Use this command to configure a OSPF ABR type. The “no ospf abr-type”
command restores the default value.
Parameter: cisco , Realize through cisco ABR; ibm, Realize through ibm ABR; shortcut,
Specify a shortcut-ABR; standard, Realize with standard（RFC2328）ABR.
Default: Cisco by default
Command Mode:
OSPF protocol mode
Usage Guide: For Specifying the realizing type of abr. This command is good for