Accton Technology ES4626 - Manual (Page 845)

845
no cluster run
Function:
Enable cluster function; the “no cluster run” command disables cluster
function.
Command mode: Global Mode
Default: Cluster function is disabled by default.
Instructions: This command enables cluster function. Cluster function has to be enabled
before implementing any other cluster commands. The “no cluster run” disables cluster
function.
Example:
Disable cluster function in the local switch.
Switch (Config)#no cluster run
22.1.3.2 cluster register timer
Command:cluster register timer
no cluster register timer
Function: Sets interval of sending cluster register packet; the “no cluster register
timer
” command restores the default setting.
Parameter: is interval of sending cluster register packet in seconds, valid
range is 30 to 65535.
Command mode: Global Mode
Default: Cluster register timer is 60 seconds by default.
Example: Set the interval of sending cluster register packet to 80 seconds.
Switch(Config)#cluster register timer 80
22.1.3.3 cluster ip-pool
Command: cluster ip-pool
no cluster ip-pool
Function: Configure private IP address pool for member switches of the cluster.
Parameter: is the IP address of the commander switch in dotted
decimal format. The value of the last byte in IP address is lower than (255-200).
Command mode:
Global Mode
Default: There is no private IP address pool by default.
Instructions: Before creating the cluster, users have to set the private IP address pool in
the commander switch. The cluster can’t be created if the private IP address pool is not
set. When candidate switches join the cluster, the commander switch assigns a private IP
address for each member switch. These IP addresses are used to communicate between
the commander switch and the member switches. This command can be only used in a
non-member switch. As soon as the cluster is created, the users can’t modify the IP
address pool. The “no cluster ip-pool” command clears the address pool and there is no