beautypg.com

3 commands for pim-sm, 1 ip pim accept-register, 2 ip pim bsr-candidate – Accton Technology ES4626 User Manual

Page 626

background image

626

16.3.3 Commands for PIM-SM

16.3.3.1 ip pim accept-register

Command: ip pim accept-register list <list-number>

no ip pim accept-register

Function:

Filter the specified multicast group and multicast address.

Parameter:

<list-number>: <list-number> is the access-list number ,it ranges from 100

to 199.

Default:

Permit the multicast registers from any sources to any groups.

Command Mode:

Global Mode

Usage Guide:

This command is used to configure the access-list filtering the PIM

REGISTER packets.The addresses of the access-list respectively indicate the filtered

multicast sources and multicast groups’ information. For the source-group combinations

that match DENY, PIM sends REGISTER-STOP immediately and does not create group

records when receiving REGISTER packets. Unlike other access-list, when the

access-list is configured ,the default value is PERMIT.

Example:

Configure the filtered register message’s rule to myfilter.

Switch(config)#ip pim accept-register list 120

Switch (config)#access-list 120 deny ip 10.1.0.2 0.0.0.255 239.192.1.10 0.0.0.255

Switch (config)#

16.3.3.2 ip pim bsr-candidate

Command: ip pim bsr-candidate {vlan <vlan-id>| <ifname>} [hash-mask-length]

[priority]

no ip pim bsr-candidate

Function:

This command is the candidate BSR configure command in global mode and

is used to configure PIM-SM information about candidate BSR in order to compete the

BSR router with other candidate BSRs. The command “no ip pim bsr-candidate”

disables the candidate BSR.

Parameter: Ifname

is the specified interface’s name;

[hash-mask-length]

is the specified hash mask length. It’s used for the RP enable

selection and ranges from 0 to 32;

[priority]

is the candidate BSR priority and ranges from 0 to 255. If this parameter

is not configured ,the default priority value is 0.

Default:

This switch is not a candidate BSR router.

Command Mode:

Global Mode

Usage Guide:

This command is the candidate BSR configure command in global mode

and is used to configure PIM-SM information about candidate BSR in order to compete

This manual is related to the following products: