Accton Technology ES4626 - Manual (Page 620)

620
event, debug pim packet, debug pim nexthop, debug pim nsm, debug pim mfc, debug
pim timer, debug pim state, refer to PIM-SM handbook.
16.2.5.1.2 debug pim timer srt
Command: debug pim timer srt
no debug pim timer srt
Function: Enable debug switch of PIM-DM state-refresh timer information in detail; the
“no debug pim timer srt” command disenables the debug switch.
Parameter: None.
Default: Disabled.
Command Mode:
Admin Mode and Global Mode.
Usage Guide:
Enable the switch, and display PIM-DM state-refresh timer information in
detail.
Example: Switch # debug ip pim timer srt
Remark: Other debug switches in PIM-DM are common in PIM-SM, including debug pim
event, debug pim packet, debug pim nexthop, debug pim nsm, debug pim mfc, debug
pim timer, debug pim state, refer to PIM-SM manual section.
16.2.5.1.3 show ip pim mroute dense-mode
Command: show ip pim mroute dense-mode [group <A.B.C.D>] [source <A.B.C.D>]
Function:
Display PIM-DM message forwarding items.
Parameter: group : displays forwarding items relevant to this multicast
address.
Source : displays forwarding items relevant to this source.
Default: Do not display (Off).
Command Mode: Admin Mode
Usage Guide: The command shows PIM-DM multicast forwarding items, namely
forwarding items of forward multicast packet in system FIB table.
Example: Display all of PIM-DM message forwarding items.
Switch(config)#show ip pim mroute dense-mode
IP Multicast Routing Table
(*,G) Entries: 1
(S,G) Entries: 1
(*, 226.0.0.1)
Local ..l.............................
(192.168.1.12, 226.0.0.1)