Accton Technology ES4626 - Manual (Page 705)

705
no ipv6 pim sparse-mode [passive]
Function:
Enable PIM-SM on the interface. no ipv6 pim sparse-mode [passive]
disables PIM-SM.
Parameter: [passive] means to disable PIM-SM (that’s PIM-SM doesn’t receive any
packets) and only enable IGMP(reveice and transmit IGMP packets).
Default: Disabled PIM-SM
Command Mode: Interface Configuration Mode
Usage Guide: Enable PIM-SM on the interface. The command can configure on IPv6
tunnel interface, but it is successful configuration to only configure tunnel carefully.
Example: Enable PIM-SM on the interface vlan1
Switch (Config)#interface vlan 1
Switch(Config-If-Vlan1)#ipv6 pim sparse-mode
17.2.4 PIM-SM Typical Application
As shown in the following figure, add the Ethernet interfaces of SwitchA, SwitchB,
switchC and switchD to corresponding vlan, and start PIM-SM Protocol on each vlan
interface.
Fig 17-2 PIM-SM Typical Environment
The configuration procedure for SwitchA, SwitchB, switchC and switchD is as below:
(1) Configure SwitchA:
Switch (Config) #ipv6 pim multicast-routing
Switch (Config) #interface vlan 1
Switch (Config-If-Vlan1) # ipv6 address 2000:12:1:1::1/64
Switch (Config-If-Vlan1) # ipv6 pim sparse-mode
Switch (Config-If-Vlan1) #exit
Switch (Config) #interface vlan 2
SwitchA SwitchB
Vlan 1 vlan 1 Vlan 2 rp Vlan 2
Vlan 2 Vlan 2 bsr
Vlan 1
Vlan 1 Vlan 3
Vlan 3
SwitchD SwitchC