11 show ip ospf interface, 12 show ip ospf neighbor – Accton Technology ES4626 User Manual
Page 480
480
2.2.3.0 192.168.1.1 1103 0x8000002b 0x0ec3 E2 2.2.3.0/24 [0x0]
13.6.5.1.11 show ip ospf interface
Command: show ip ospf interface
Function:
Display the OSPF interface messages
Parameter:
name of interface
Default:
Not displayed
Command Mode:
All modes
Example:
Switch#show ip ospf interface
Loopback is up, line protocol is up
OSPF not enabled on this interface
Vlan1 is up, line protocol is up
Internet Address 10.10.10.50/24, Area 0.0.0.0
Router ID 10.10.11.50, Network Type BROADCAST, Cost: 10
Transmit Delay is 5 sec, State Waiting, Priority 1
No designated router on this network
No backup designated router on this network
Timer intervals configured, Hello 35, Dead 35, Wait 35, Retransmit 5
Hello due in 00:00:16
Neighbor Count is 0, Adjacent neighbor count is 0
13.6.5.1.12 show ip ospf neighbor
Command: show ip ospf [
|interface<ifaddress>}]
Function:
Display the OSPF adjacent point messages
Parameter:
is the process ID ranging between 0~65535
<neighbor_id>
is the dotted decimal notation neighbor ID
all: Display messages of all neighbors
detail: Display detailed messages of all neighbors
<ifaddress>
Interface IP address
Default:
Not displayed
Command Mode:
All modes
Usage Guide:
OSPF neighbor state can be checked by viewing the output of this
command
Example:
Switch#show ip ospf neighbor
OSPF process 0:
Neighbor ID Pri State Dead Time Address Interface