Accton Technology ES4626 - Manual (Page 191)

191
Configuration
Item
Configuration Explanation
VLAN-translation Port1 of PE1 and PE2
Trunk port Port1 and Port10 of PE1 and PE2
Configuration procedure is as follows
PE1、PE2:
Switch (Config)#interface ethernet 1/1
Switch (Config-Ethernet1/1)#switchport mode trunk
Switch (Config-Ethernet1/1)# dot1q-tunnel enable
Switch (Config-Ethernet1/1)# vlan-translation enable
Switch (Config-Ethernet1/1)# vlan-translation 20 to 3 in
Switch (Config-Ethernet1/1)# vlan-translation 3 to 20 out
Switch (Config-Ethernet1/1)# exit
Switch (Config)#interface ethernet 1/10
Switch (Config-Ethernet1/10)#switchport mode trunk
Switch (Config-Ethernet1/10)#exit
Switch (Config)#
5.4.5 VLAN-translation Troubleshooting
z Normally the VLAN-translation is applied on trunk ports.
z Normally before using the VLAN-translation, the dot1q-tunnel function needs to be
enabled, becoming adaptable to double tag data packet and translating the VLAN
normally.
z Configuring in port-channel is not supported.
5.5 Dynamic VLAN Configuration
5.5.1 Dynamic VLAN Introduction
The dynamic VLAN is named corresponding to the static VLAN (namely the port
based VLAN). Dynamic VLAN supported by the ES4624-SFP/26-SFP switch includes
MAC-based VLAN, IP-subnet-based VLAN and Protocol-based VLAN. Detailed
description is as follows
The MAC-based VLAN division is based on the MAC address of each host, namely