Accton Technology ES4626 - Manual (Page 273)

273
Displayed information Explanation
aggregate-policer policer1 80000 80
exceed-action drop
Configuration for this policy set.
Not used by any policy map Time that the policy set is being
referred to
8.1.5.1.4 show mls qos interface
Command: show mls qos interface [<interface-id>] [buffers | policers | queueing |
statistics]
Function: Displays QoS configuration information on a port.
Parameters: <interface-id> is the port ID; buffers is the queue buffer setting on the port;
policers
is the policy setting on the port; queuing is the queue setting for the port;
statistics is the number of packets allowed to pass for in-profile and out-of-profile traffic
according to the policy bound to the port.
Default: N/A.
Command mode: Admin Mode
Usage Guide: Statistics are available only when ingress policy is configured.
Example:
Switch #show mls qos interface ethernet 1/2
Ethernet1/2
default cos:0
DSCP Mutation Map: Default DSCP Mutation Map
Attached policy-map for Ingress: p1
Displayed information Explanation
Ethernet1/2 Port name
default cos:0 Default CoS value of the port.
DSCP Mutation Map: Default DSCP Mutation
Map
Port DSCP map name
Attached policy-map for Ingress: p1 Policy name bound to port.
Switch # show mls qos interface buffers ethernet 1/2
Ethernet1/2
packet number of 8 queue:
0x200 0x200 0x200 0x200 0x200 0x200 0x200 0x200
Displayed information Explanation
packet number of 8 queue: Available packet number for all 8