Accton Technology ES4626 - Manual (Page 283)

283
（ 2） Configure send neighbor query message interval
（ 3） Enable and forbid router announce
（ 4） Configure router announce lifespan
（ 5） Configure router announce maximum interval
（ 6） Configure router announce maximum interval
（ 7） Configure prefix announce parameters
（ 8） Set static neighbor table entries
（ 9） Clear neighbor table entries
3. IPv6 Tunnel configuration
（ 1） Create/Delete Tunnel
（ 2） Configure Tunnel Source
（ 3） Configure Tunnel Destination
（ 4） Configure Tunnel Next-Hop
（ 5） Configure 6to4 Tunnel Relay
（ 6） Configure Tunnel Mode
（ 7） Configure Tunnel Routing
1. IPv6 Basic Configuration
(1). Globally enable IPv6
Command Explanation
Global mode
[no] ipv6 enable
Enable functions such as IPv6 data packet
transmission, neighbor discovery, router
announcement, routing protocol, etc. The
NO command shuts IPv6 function.
(2). Configure interface IPv6 address
Command Explanation
Interface Configuration Mode
ipv6 address <ipv6-address/prefix-length>
[eui-64]
no ipv6 address <ipv6-address/prefix-length>
Configure IPv6 address,
including aggregatable global
unicast addresses, local site
addresses and local link
addresses. The no ipv6
address
<ipv6-address/prefix-length>
command cancels IPv6
address.