Accton Technology ES4626 - Manual (Page 46)

46
]
Function:
This command is tests the gateway passed in the route of a packet from the
source device to the target device. This can be used to test connectivity and locate a
failed sector.
Parameter: is the target host IP address in dot decimal format.
is the hostname for the remote host. is the maximum gateway number allowed
by Traceroute command. Is the timeout value for test packets in milliseconds,
between 100 -10000.
Default:
The default maximum gateway number is 16, timeout in 2000 ms.
Command mode: Admin Mode
Usage Guide: Traceroute is usually used to locate the problem for unreachable network
nodes.
2.1.1.29 traceroute6
Command: traceroute6 {<ipv6-addr> | host <hostname> }[hops ] [timeout
]
Function: This command is for testing the gateways passed by the data packets from
the source device to the destination device, so to check the accessibility of the network
and further locating the network failure.
Parameter： is the IPv6 address of the destination host,shown in colonned
hex notation; is the name of the remote host; is the max number of
the gateways the traceroute6 passed through,ranging between 1-255; is the
timeout period of the data packets,shown in millisecond and ranging between
100~10000.
Default: Default number of the gateways pass by the data packets is 16, and timeout
period is defaulted at 2000 ms
Command Mode: Admin Mode
Usage Guide: Traceroute6 is normally used to locate destination network inaccessible
failures.
Example:
Switch# traceroute6 2004:1:2:3::4
Relevant Command:ipv6 host
2.1.1.30 cli username
Command：cli username [privilege < privilege >] [ password (0|7)
]
no cli username
Function： Configure shell user and priority shell by logging in user name and password.