Accton Technology ES4626 - Manual (Page 149)

149
z Two connected fiber interfaces won’t link up if one interface is set to
auto-negotiation but the other to forced speed/duplex. This is determined by IEEE
802.3.
z The following combinations are not recommended: enabling traffic control as well
as setting multicast limiting for the same port; setting broadcast, multicast and
unknown destination unicast control as well as port bandwidth limiting for the same
port. If such combinations are set, the port throughput may fall below the expected
performance
3.6 Web Management
Click “Port configuration” to open the port configuration management table. Users can
proceed to do port management, setup port speed, duplexes and so on.
3.6.1 Ethernet port configuration
Click “Port configuration”, “Ethernet port configuration” to open the Ethernet port
configuration management table to configure Ethernet port duplex, speed, bandwidth
control and so on.
3.6.2 Physical port configuration
Click “port configuration”, “Ethernet port configuration”, “Physical port configuration” to
configure the following information:
z Port: Specifies the configuration port
z MDI: Sets up the connection type of the Ethernet port. Auto means to auto-negotiate
connection type; across means the port supporting cross-over cable only; normal
means the port supporting straight-through cable only.
z Admin Status: Enables/Disables port.
z speed/duplex status: Sets up Ethernet sport speed and duplex including,
auto-negotiation, 10Mbps Half, 10Mbps Full, 100Mbps Half, 100Mbps Full,
1000Mbps Half, 1000Mbps Full.
z Port flow control status: Sets up port flow control including disabled flow control and
enabled flow control.
z Loopback: Sets up Ethernet port to enable loopback testing function.
Example: Assign port to be Ethernet 1/1 and set up MDI as normal; Admin control status
as no shutdown, speed/duplex as auto, port flow control status as disabled flow control
and Loopback as no loopback. Then click Apply button and these set up items will be