5 ipv6 nd ns-interval, 6 ipv6 nd suppress-ra – Accton Technology ES4626 User Manual
Page 289
289
no ipv6 nd dad attempts
Function：
Set Neighbor Request Message number sent in succession by interface when
setting Repeat Address Check..
Parameter：<value>
is the Neighbor Request Message number sent in succession by
Repeat Address Check, and the value of <value> must be in 0-10, NO command
restores to default value 1.
Command Mode：
Interface Configuration Mode
Default：
The default request message number is 1
Usage Guide：
When configuring an IPv6 address, it is required to process IPv6 Repeat
Address Check, this command is used to configure the ND message number of Repeat
Address Check to be sent, value being 0 means no Repeat Address Check is executed.
Example：
The Neighbor Request Message number sent in succession by interface when
setting Repeat Address Check is 3..
Switch(Config-if-Vlan1)# ipv6 nd dad attempts 3
9.2.2.3.1.5 ipv6 nd ns-interval
Command：ipv6 nd ns-interval
no ipv6 nd ns-interval
Function：
Set the time interval of Neighbor Request Message sent by the interface
Parameter：
parameter <seconds> is the time interval of sending Neighbor Request
Message, <seconds> value must be between 1-3600 seconds, no command restores
the default value 1 second.
Command Mode：
Interface Configuration Mode
Default：
The default Request Message time interval is 1 seconds.
Default：
The value to be set will include the situation in all routing announcement on the
interface. Generally, very short time interval is not recommended.
Example：
Set Vlan1 interface to send out Neighbor Request Message time interval to be
8 seconds.
Switch(Config-if-Vlan1)#ipv6 nd ns-interval 8
9.2.2.3.1.6 ipv6 nd suppress-ra
Command：
[no] ipv6 nd suppress-ra
Function：Prohibit router announcement.
Parameter：
None
Command Mode：
Interface Configuration Mode
Default Situation：
There is not Enable router announcement function.
Usage Guide：
no ipv6 nd suppress-ra command enable router announcement function.
Example：
Enable router announcement function.