Artesyn ATCA-8310 Installation and Use (May 2014) - Manual (Page 80)

Functional Description
ATCA-8310 Installation and Use (6806800M72E) 80
4.3.2.2 Ibex-Peak Display
The Ibex-Peak provides a VGA interface at the front panel via DSUB-15.
4.3.2.3 Ibex-Peak LPC
The LPC interface is connected to the Glue-Logic FPGA. A Super I/O will not be used for the
ATCA-8310.
4.3.2.4 Ibex-Peak SPI
The SPI interface will be connected to the Glue-Logic FPGA. Inside the FPGA the redundant
BOOT-Flash choice and the BIOS update over IPMI will be implemented.
4.3.2.5 Ibex-Peak SATA
SATA port 1 is routed to the onboard 1.8'' SSD. All other SATA-Ports are not used on the ATCA-
8310.
4.3.2.6 Ibex-Peak USB
USB port 1 and 2 are routed to the front panel.
4.3.2.7 GPP System Management Bus (SMBus)
The Ibex-Peak contains a SMBus Host interface that allows the processor to communicate with
SMBus slaves. This interface is compatible with most I2C devices. Special I2C commands are
implemented.
5 Not used
6 Gigabit Controller 82574
7-8 Not used
Table 4-3 PCI Express Interface of the Ibex-Peak
PORT Destination