Artesyn ATCA-8310 Installation and Use (May 2014) - Manual (Page 178)

U-Boot
ATCA-8310 Installation and Use (6806800M72E) 178
The parameters to the "fru" command are
 open
To open a local FRU, where is
– 0 for the SPP FRU
– 1 for the FRU of the onboard DSP module (DMC0)
– 2 for the 1st DMC module
– 3 for the 2nd DMC module
– 4 for the GPP FRU
– 5 for the RTM baseboard
– 6 for the RTM mezzanine card
 close
Closes the currently opened fru data
 save
Saves modifications to the fru data
 set
Set various parameters in the currently opened fru data
 show
Display the currently opened fru data
FRU information on the shelf manager can be viewed using the "ipmi fru remote shm"
command. For example, to display the shelf FRU information provided by the shelf manager,
call:
ipmi fru remote shm 254
fru show
fru close
It is not recommended for the customer to modify FRU data. This feature is intended for
factory use only.