Artesyn ATCA-8310 Installation and Use (May 2014) - Manual (Page 179)

U-Boot
ATCA-8310 Installation and Use (6806800M72E) 179
6.2.1.7.2 BootProgress Indication
Boot progress is reported to the IPMC via a platform event message. The relevant fields are the
sensor type byte and event data bytes 1, 2 and 3.
The following table lists the events sent throughout the boot process:
Table 6-6 Boot Process Events
Sensor Type
Event Data Byte
Description / Mnemonic 1 2 3
FW Progress
(0x1f) 0 POST Error:
1 0xff NO_SYSTEM_MEMORY_INSTALLED
2 NO_USABLE_SYSTEM_MEMORY
4 SYSTEM_BOARD_FAILURE
6 HARD_DISK_CONTROLLER_FAILURE
0xb ROM_CORRUPTION_DETECTED
0xfd Artesyn Specific error value.
2 Firmware Progress
1 0xff MEMORY_INIT
When initializing the DRAM
3 SECONDARY_PROCESSOR_INIT
When taking Intel CPU out of reset
5 USER_INITIATED_SYSTEM_SETUP
When entering the shell
0x13 STARTING_OS_BOOT_PROCESS
Immediately before executing the boot image
0x14 BASEBOARD_INIT
When initializing glue logic
0x19 PRIMARY_PROCESSOR_INIT
Early boot stage
0xfd Artesyn specific progress value in event data 3.
OS Boot (0x0f) OS Specific