Artesyn ATCA-8310 Installation and Use (May 2014) - Manual (Page 60)

Controls, Indicators, and Connectors
ATCA-8310 Installation and Use (6806800M72E) 60
3.1.3 Connectors
The blade provides the following face plate interfaces and control elements:
 For GPP:
– Two USB 2.0 ports
– D-SUB15 VGA connector
– Serial console port to connect to either GPP or IPMC serial I/F
– One 1000Base-T Ethernet port
 For SPP:
– Serial console port to connect to SPP
– One USB 2.0 port
 For IPMI:
– Out of Service, In Service, Attention, and Hot Swap LED's (IPMC control)
– LED's connected to FPGA for BASE IF and Faceplate IF Link Control (FPGA control)
– Recessed reset button
3.2 Onboard Connectors
The blade provides the following on-board connectors:
 2x Module Connector for DSP-Mezzanine Card
3.3 ATCA Backplane Connectors
The ATCA specification defines Zone 3 for user input/output signals. On ATCA-8310 ATCA Zone
3 Type A connector (direct connect to RTM) are used. The same connectors are used for Zone
2 and Zone 3. Zone 3 connectors are assigned to reference designators P30 through P32.
Zone 3 Connector P30 is the top most connector. P31 is below P30. P32 is below P31. Zone 3
connectors carry the signals as described in the following tables.