Artesyn ATCA-8310 Installation and Use (May 2014) - Manual (Page 229)

Intelligent Peripheral Management Controller
ATCA-8310 Installation and Use (6806800M72E) 229
The serial line selection is implemented non-persistently to ensure, that the serial interfaces
always can be accessed easily after power-up. By default the serial line selection selects the
front-panel connectors after power-up.
7.13 Built-in Terminal Server
The ATCA-8310 provides a built-in terminal server (TS) based on the embedded controller
MCF5223X ColdFire from Freescale. All serial payload data can be accessed via the Terminal
Server.
The IPMC is selecting the serial source to be routed to the terminal server and configures the TS
specific parameters via a separate communication interface (I2C):
 MAC address
 IP addresses
 Net mask
 Gateway IP address
 Baud rate
Depending on the serial line selection, either the payload serial interface of the SPP or the serial
interface of the GPP can be accessed via telnet protocol.
Figure 7-5 Com #1 Serial Line Selection
Renesas H8S
2166 (IPMC)
P4080
Glue
Logic
FPGA
CO
M
0
Front face plate
connector #1
Terminal Server
COM_ROUTE_C
COM 0
CO
M 0