Artesyn ATCA-8310 Installation and Use (May 2014) - Manual (Page 57)

Controls, Indicators, and Connectors
ATCA-8310 Installation and Use (6806800M72E) 57
The LEDs are described in the following table.
Table 3-1 Face Plate LEDs
LED Description
OOS Out Of Service
Red/optional Amber (controllable by IPMC): This LED is controlled by higher
layer software, such as middle ware or applications.
IS Payload Power Status
Green: The payload power has been enabled by the IPMC. Note that this LED
indicates the payload power status both in the early power state and the
normal blade operation.
OFF: Payload power is disabled
Note: This LED is multicolored (red/green/yellow) and is programmable by
IPMC.
ATN Amber: This LED is controlled by higher layer software, such as middle ware or
applications.
ETH Status LEDs The Ethernet connector provides two status LEDs
Link (upper)
Green: Link is available
Off: No link
Activity (lower)
Yellow: Activity
Off: No activity
U1, U2 Base interface activity is visualized via FPGA LEDs U1 and U2
U3 User LED, selectable color via FPGA register.
Colors: red, green, orange