Artesyn ATCA-8310 Installation and Use (May 2014) - Manual (Page 230)

Intelligent Peripheral Management Controller
ATCA-8310 Installation and Use (6806800M72E) 230
The Shelf Manager can configure the TS with the use of the IPMI commands Set/Get LAN
Configuration Parameters and Set/Get SOL Configuration parameter.
There are two dedicated TS OEM channel available (channel = 0x05,0x06) defined to be used
with both Base Interfaces.
The built-in terminal server is not implemented with the use of RMCP packets. Furthermore
there is no SOL client required to establish a telnet session.
Due to the fact, that there is no authenticated IPMI communication to the IPMC, the channels
are implemented IPMI session-less. For TS channel properties, see the table below:
7.13.1 Evaluating the Version of the Telnet Server Firmware
The firmware version of the terminal server can be retrieved with the IPMI command "Get SOL
Configuration" executed with the OEM parameter 192.
ipmicmd -k "0 0 c 22 5 C0 0 0" smi 0
Table 7-8 TS Channel Information
Channel Protocol Type OEM Protocol 0x1C
Channel Medium Type OEM 0x60
Session support Session-less 0x00
Vendor ID Artesyn IANA 0xCD 0x65 0x00
Auxiliary Channel Info