Artesyn ATCA-8310 Installation and Use (May 2014) - Manual (Page 238)

Intelligent Peripheral Management Controller
ATCA-8310 Installation and Use (6806800M72E) 238
7.22.1 Set Serial Output Command
This command allows users to set the serial output source for a particular serial port connector.
Table 7-10 Set Serial Output Command
Byte Data Field
Request Data 1 LSB of Artesyn IANA Enterprise Number. A value of
CDh shall be used.
2 2nd byte of Artesyn IANA Enterprise Number. A value
of 65h shall be used.
3 MSB of Artesyn IANA Enterprise Number. A value of
00h shall be used.
4 Serial connector type:
0 = Front panel connector
1,2 = reserved
3 = Onboard device (i.e Terminal Server, P4080 COM
#1 to Intel COM #0)
All other values are reserved.
5 Serial connector instance number. A sequential
number starts from zero.
6 Serial output selector
Response Data 1 Completion Code
2 LSB of Artesyn IANA Enterprise Number. A value of
CDh shall be used.
3 2nd byte of Artesyn IANA Enterprise Number. A value
of 65h shall be used.
4 MSB of Artesyn IANA Enterprise Number. A value of
00h shall be used.