Artesyn ATCA-8310 Installation and Use (May 2014) - Manual (Page 242)

Intelligent Peripheral Management Controller
ATCA-8310 Installation and Use (6806800M72E) 242
The following table provides the feature set supported with ATCA-8310:
7.22.4 Get Feature Configuration
This command can be used to retrieve the IPMI feature set being configured.
Table 7-14 Feature Selector Assignments
Feature Selector Description
E0h FAILSAFE Function Enable/Disable
E1h Select FPGA flash
Table 7-15 Get Feature Configuration Command
Byte Data Field
Request Data 1 LSB of Artesyn IANA Enterprise Number. A value of CDh shall be used.
2 2nd byte of Artesyn IANA Enterprise Number. A value of 65h shall be used.
3 MSB of Artesyn IANA Enterprise Number. A value of 00h shall be used.
4 Feature Selector
Response Data 1 Completion Code. Generic plus the following command-specific completion
codes:
80h = feature selector not supported.
2 LSB of Artesyn IANA Enterprise Number. A value of CDh shall be used.
3 2nd byte of Artesyn IANA Enterprise Number. A value of 65h shall be used.
4 MSB of Artesyn IANA Enterprise Number. A value of 00h shall be used.
5 Feature Configuration
00h = disabled (Feature Selector = E0)
01h = enabled (Feature Selector = E0)
02h = restore factory default (golden) (Feature Selector = E1)
C0h = reload selected FPGA image (Feature Selector = E1)
C1h = enabled and activated (Feature Selector = E0)
03h - FFh = reserved
6 Persistency / Duration