NEC Network Controller uPD98502 - Manual (Page 149)

CHAPTER 2 V R 4120A
Preliminary User’s Manual S15543EJ1V0UM 149
2.5.4.8 TLB exceptions
Three types of TLB exceptions can occur:
• TLB Refill exception occurs when there is no TLB entry that matches a referenced address.
• A TLB Invalid exception occurs when a TLB entry that matches a referenced virtual address is marked as
being invalid (with the V bit set to 0).
• The TLB Modified exception occurs when a TLB entry that matches a virtual address referenced by the store
instruction is marked as being valid (with the V bit set to 1).
The following three sections describe these TLB exceptions.
(1) TLB refill exception (32-bit space mode)/XTLB refill exception (64-bit space mode)
(a) Cause
The TLB Refill exception occurs when there is no TLB entry to match a reference to a mapped address space.
This exception is not maskable.
(b) Processing
There are two special exception vectors for this exception; one for references to 32-bit address spaces, and one
for references to 64-bit address spaces. The UX, SX, and KX bits of the Status register determine whether the
user, supervisor or kernel address spaces referenced are 32-bit or 64-bit spaces. When the EXL bit of the Status
register is set to 0, either of these two special vectors is referenced. When the EXL bit is set to 1, the common
exception vector is referenced.
This exception sets the TLBL or TLBS code in the ExcCode field of the Cause register. If this exception has been
caused by an instruction reference or load operation, TLBL is set. If it has been caused by a store operation,
TLBS is set.
When this exception occurs, the BadVAddr, Context, XContext and EntryHi registers hold the virtual address that
failed address translation. The EntryHi register also contains the ASID from which the translation fault occurred.
The Random register normally contains a valid location in which to place the replacement TLB entry. The
contents of the EntryLo register are undefined.
The EPC register contains the address of the instruction that caused the exception. However, if this instruction is
in a branch delay slot, the EPC register contains the address of the preceding jump or branch instruction, and the
BD bit of the Cause register is set to 1.
(c) Servicing
To service this exception, the contents of the Context or XContext register are used as a virtual address to fetch
memory words containing the physical page frame and access control bits for a pair of TLB entries. The memory
word is written into the TLB entry by using the EntryLo0, EntryLo1, or EntryHi register.
It is possible that the physical page frame and access control bits are placed in a page where the virtual address is
not resident in the TLB. This condition is processed by allowing a TLB Refill exception in the TLB Refill exception
handler. In this case, the common exception vector is used because the EXL bit of the Status register is set to 1.