PLANET WGSW-52040 - Manual (Page 89)

1-88
Enables the switch to be a DHCP client and obtain IP address and gateway address through DHCP negotiation; the
“no ip dhcp-client enable” command disables the DHCP client function and releases the IP address obtained in
DHCP. Note: To obtain IP address via DHCP, a DHCP server is required in the network.
Default:
the DHCP client function is disabled by default.
Command mode:
VLAN Interface Mode
Usage Guide:
Obtaining IP address by DHCP, Manual configuration and BootP are mutually exclusive, enabling any 2 methods for
obtaining an IP address is not allowed.
Example:
Getting an IP address through DHCP.
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip dhcp-client enable
Switch(Config-if-Vlan1)#exit
Switch(config)#
1.4 Commands for SNMP
1.4.1 debug snmp mib
Command:
debug snmp mib
no debug snmp mib
Function:
Enable the SNMP mib debugging; the "no debug snmp mib” command disables the debugging.
Command Mode:
Admin Mode.
Usage Guide:
When user encounters problems in applying SNMP, the SNMP debugging is available to locate the problem causes.