PLANET WGSW-52040 - Manual (Page 493)

30-33
Switch(config)# ip dhcp relay information option self-defined subscriber-id format hex
30.10 ip dhcp relay information option subscriber-id
Command:
ip dhcp relay information option subscriber-id {standard | }
no ip dhcp relay information option subscriber-id
Function:
This command is used to set the format of option82 sub-option1(Circuit ID option) added to the DHCP request
messages from interface, standard means the standard vlan name and physical port name format,
like”Vlan2+Ethernet1/12”, is the circuit-id contents of option82 specified by users, which is a string no
longer than 64 characters. The” no ip dhcp relay information option subscriber-id” command will set the format
of added option82 sub-option1 (Circuit ID option) as standard format.
Parameters:
None
Command Mode:
Interface configuration mode.
Default Settings:
The system uses the standard format to set the circuit-id of option 82 by default.
User Guide:
Because the option 82 information added for the switch should cooperate with the third party DHCP server, if the
standard circuit-id format of the switch cannot satisfy the server’s request, this method will be provided for users to
specify the contents of circuit-id according to the situation of the server.
Example:
Set the sub-option circuit-id of DHCP option82 as foobar.
Switch(config-if-vlan1)#ip dhcp relay information option subscriber-id foobar