PLANET WGSW-52040 - Manual (Page 286)

17-55
Example:
Set the native VLAN for a Trunk port to 100.
Switch(config)#interface ethernet 1/5
Switch(Config-If-Ethernet1/5)#switchport mode trunk
Switch(Config-If-Ethernet1/5)#switchport trunk native vlan 100
Switch(Config-If-Ethernet1/5)#exit
17.1.36 vlan
Command:
vlan WORD
no vlan WORD
Function:
Create VLANs and enter VLAN configuration mode. If using ';' and '-' connect with multi-VLANs, then only create
these VLANs. If only existing VLAN, then enter VLAN configuration mode; if the VLAN is not exist, then create VLAN
and enter VLAN configuration mode. In VLAN Mode, the user can set VLAN name and assign the switch ports to the
VLAN. The no command deletes specified VLANs.
Parameter:
WORD is the VLAN ID to be created/deleted, valid range is 1 to 4094, connect with ';' and '-'.
Command mode:
Global Mode.
Default:
Only VLAN1 is set by default.
Usage Guide:
VLAN1 is the default VLAN and cannot be configured or deleted by the user. The maximal VLAN number is 4094. It
should be noted that dynamic VLANs learnt by GVRP cannot be deleted by this command.
Example:
Create VLAN100 and enter the configuration mode for VLAN 100.
Switch(config)#vlan 100
Switch(Config-Vlan100)#