PLANET WGSW-52040 - Manual (Page 664)

41-204
Enable/disable AM function on port.
Parameters:
None.
Default:
AM function is disabled on all port.
Command Mode:
Port Mode.
Example:
Enable AM function on interface 1/3 of the switch.
Switch(Config-If-Ethernet 1/3)#am port
Disable AM function on interface 1/3 of the switch.
Switch(Config-If-Ethernet 1/3)#no am port
41.3 am ip-pool
Command:
am ip-pool <ip-address>
no am ip-pool
Function:
Set the AM IP segment of the interface, allow/deny the IP messages or APR messages from a source IP within that
segment to be forwarded via the interface.
Parameters:
the starting address of an address segment in the IP address pool; is the number of
consecutive addresses following ip-address, less than or equal with 32.
Default:
IP address pool is empty.
Command Mode:
Port Mode.
Usage Guide: