PLANET WGSW-52040 - Manual (Page 603)

38-143
Parameters:
is the access-list No. which is a decimal’s No. from 1100-1199; deny if rules are matching, deny access;
permit if rules are matching, permit access; any source address; any
destination address; , source MAC address; mask (reverse mask) of source
MAC address; , destination MAC address; mask (reverse mask) of
destination MAC address; untagged-eth2 format of untagged ethernet II packet; tagged-eth2 format of tagged
ethernet II packet; untagged-802-3 format of untagged ethernet 802.3 packet; tagged-802-3 format of tagged
ethernet 802.3 packet.
Command Mode:
Global mode
Default Configuration:
No access-list configured
Usage Guide:
When the user assign specific for the first time, ACL of the serial number is created, then the lists are added
into this ACL.
Examples:
Permit tagged-eth2 with any source MAC addresses and any destination MAC addresses and the packets pass.
Switch(config)#access-list 1100 permit any-source-mac any-destination-mac tagged-eth2
38.6 access-list(mac-ip extended)
Command:
access-list{deny|permit}{any-source-mac| {host-source-mac}|{}}
{any-destination-mac|{host-destination-mac }|{}}icmp
{{}|any-source|{host-source}}
{{}|any-destination|
{host-destination}}[ []] [precedence ] [tos
][time-range]
access-list{deny|permit}{any-source-mac| {host-source-mac}|{}}
{any-destination-mac|{host-destination-mac }|{}}igmp
{{}|any-source|{host-source}}
{{}|any-destination| {host-destination}}
[] [precedence ] [tos ][time-range]