PLANET WGSW-52040 - Manual (Page 552)

35-92
ACL of Multicast destination control list item is controlled by specifical ACL number from 6000 to 7999, the command
applies to configure this ACL. ACL of Multicast destination control only needs to configure source IP address and
destination IP address controlled (group IP address), the configuration mode is basically the same to other ACLs,
and use wildcard character to configure address range, and also specify a host address or all address. Remarkable,
“all address” is 224.0.0.0/4 according to group IP address, not 0.0.0.0/0 in other access-list.
Example:
Switch(config)#access-list 6000 permit ip 10.1.1.0 0.0.0.255 232.0.0.0 0.0.0.255
Switch(config)#
35.1.2 access-list (Multicast Source Control)
Command:
access-list <5000-5099> {deny|permit} ip {{ }|{host}|any-source}
{{ }|{host-destination }|any-destination}
no access-list <5000-5099> {deny|permit} ip {{ }|{host }|any}
{{ }|{host-destination }|any-destination}
Function:
Configure source control multicast access-list; the “no access-list <5000-5099> {deny|permit} ip {{
}|{host }|any-source} {{
}|{host-destination }|any-destination}” command deletes the
access-list.
Parameter:
<5000-5099>: source control access-list number.
{deny|permit}: deny or permit.
: multicast source address..
: multicast source address wildcard character.
: multicast source host address.
: multicast destination address.
: multicast destination address wildcard character.
: multicast destination host address.
Default:
None