PLANET WGSW-52040 - Manual (Page 636)

39-176
39.13 dot1x user allow-movement
Command:
dot1x user allow-movement
no dot1x user allow-movement
Function:
Enable the authentication function after the user moves the port, the no command disables the function.
Command Mode:
Global mode
Default:
Disable the authentication function after the user moves the port.
Usage Guide:
Enable the authentication function after the user moves the port, so the switch allows user to process this
authentication. In the condition that the switch connects with hub, when the user will be moved to other port, dot1x
user allow-movement command should be enabled.
Example:
Enable the authentication function after the user moves the port.
Switch(config)#dot1x user allow-movement
39.14 dot1x user free-resource
Command:
dot1x user free-resource
no dot1x user free-resource
Function:
To configure 802.1x free resource; the no form command closes this function.
Parameter:
<prefix> is the segment for limited resource, in dotted decimal format;
<mask> is the mask for limited resource, in dotted decimal format.
Command Mode: