PLANET WGSW-52040 - Manual (Page 256)

16-25
Chapter 16 Commands for EEE
Energy-saving
16.1 eee enable
Command:
eee enable
no eee enable
Function:
Configure the port to enable eee energy-saving function; the no command deletes it.
Parameters:
None.
Command Mode:
Port Mode.
Default:
None.
Usage Guide:
It supports that configure EEE energy-saving function for the appointed port. There is not the EEE energy-saving
function on port as default. After configuring the port to enable EEE energy-saving function, the port will enter the
energy-saving state if stop to send packets to the port, the state of port is down. When sending packets to the port,
the mode will changed from power saving mode to normal mode.
Example:
Enable EEE energy-saving function:
Switch(config-if-ethernet1/1)#eee enable