PLANET WGSW-52040 - Manual (Page 168)

7-167
Usage Guide:
Use this command to display all kinds of event information.
Example:
Display event information.
Switch#debug uldp event
7.4 debug uldp fsm interface ethernet
Command:
debug uldp fsm interface ethernet >
no debug uldp fsm interface ethernet <IFname>
Function:
To enable debugging information for ULDP for the specified interface. The no form of this command will disable the
debugging information.
Parameters:
> is the interface name.
Command Mode:
Admin Configuration Mode.
Default:
Disabled by default.
Usage Guide:
This command can be used to display the information about state transitions of the specified interfaces.
Example:
Print the information about state transitions of interface ethernet 1/1.
Switch#debug uldp fsm interface ethernet 1/1