PLANET WGSW-52040 - Manual (Page 554)

35-94
Example:
Switch(config)#inter e 1/4
Switch(Config-If-Ethernet 1/4)#ip multicast destination-control access-group 6000
Switch (Config-If-Ethernet1/4)#
35.1.4 ip multicast destination-control access-group (sip)
Command:
ip multicast destination-control access-group <6000-7999>
no ip multicast destination-control access-group <6000-7999>
Function:
Configure multicast destination-control access-list used on specified net segment, the “no ip multicast
destination-control access-group <6000-7999>” command deletes this configuration.
Parameter:
: IP address and mask length;
<6000-7999>: Destination control access-list number.
Default:
None
Command Mode:
Global Mode
Usage Guide:
The command is only working under global multicast destination-control enabled, after configuring the command, if
IGMP-SPOOPING or IGMP is enabled, for adding the members to multicast group. If configuring multicast
destination-control on specified net segment of transmitted igmp-report, and match configured access-list, such as
matching permit, the interface can be added, otherwise do not be added. If relevant group or source in show ip igmp
groups detail has been established before executing the command, it needs to execute clear ip igmp groups
command to clear relevant groups in Admin mode.
Example:
Switch(config)#ip multicast destination-control 10.1.1.0/24 access-group 6000