PLANET WGSW-52040 - Manual (Page 650)

40-190
40.2 debug ipv6 nd count
Command:
debug ipv6 nd count
no debug ipv6 nd count
Function:
When the number limitation function debug of neighbor in the VLAN, if the number of dynamic neighbor and the
number of neighbor in the VLAN is larger than the max number allowed, users will see debug information. ”no
debug ip neighbor count” command is used to disable the number limitation function debug of neighbor in the
VLAN.
Parameters:
None.
Command Mode:
Admin Mode.
Default Settings:
None.
Usage Guide:
Display the debug information of the number of dynamic neighbor in the VLAN.
Examples:
Switch#debug vlan mac count
%Jun 14 16:04:40 2007 Current neighbor count 21 is more than or equal to the maximum limit in vlan 1!!
40.3 debug switchport arp count
Command:
debug switchport arp count
no debug switchport arp count
Function:
When the number limitation function debug of ARP on the port, if the number of dynamic ARP and the number of
ARP on the port is larger than the max number allowed, users will see debug information.” no debug switchport arp