PLANET WGSW-52040 - Manual (Page 300)

17-69
Ethernet1/3(A) Ethernet1/4(A)
Ethernet1/5(H) Ethernet1/6(T)
17.3.12 subnet-vlan
Command:
subnet-vlan ip-address mask > vlan priority
no subnet-vlan {ip-address mask | all}
Function:
Add a correspondence between the IP subnet and the VLAN, namely add specified IP subnet into specified VLAN;
the no form of this command deletes all/the correspondence.
Parameter:
ipv4-address is the IPv4 address shown in dotted decimal notation; the valid range of each section is 0~255;
subnet-mask is the subnet mask code shown in dotted decimal notation; the valid range of each section is 0~255;
priority-id is the priority applied in the VLAN tag with a valid range of 0~7; vlan-id is the VLAN ID with a valid range of
1~4094;all indicates all the subnets.
Command Mode:
Global Mode.
Default:
No IP subnet joined the VLAN by default.
Usage Guide:
This command is used for adding specified IP subnet to specified VLAN. When packet without VLAN label and from
the specified IP subnet enters through the switch port, it will be matched with specified VLAN id and enters specified
VLAN. These packets will always come to the same VLAN no matter through which port did they enter. This
command will not interfere with VLAN labeled data packets.
Example:
Add the network equipment with IP subnet of 192.168.1.0/24 to VLAN 300.
Switch#config
Switch(config)#subnet-vlan ip-address 192.168.1.1 mask 255.255.255.0 vlan 300 priority 0